E3D V6 Stainless Steel Heater Block for Sensor Cartridges

The V6 heater block has been updated to clamp the cartridge and thermistor in place. These design improvements improve the thermal response of the hot end and facilitate the assembly of the thermistors.

This product is also supplied with the following fastenings:

• Allen screw
• M3x0.5x4
• Washer for clamping the thermistor
• Allen screw M3x0.5x10 for clamping the heating cartridge

Compatibility

V5 and V6 heating blocks are cross-compatible. Both use an M6 thread. Note that the V6 heating blocks are 0.5 mm shorter than V5.